HOME › Forums › Input/Output › EZIOxx › Connection diagram for 1-wire on EZIO8SA

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • Anonymous
    Inactive
    May 22, 2015 at 2:23 am
    Post count: 5
    #40471

    I have a few 1-wire thermostats of the right type but they didn’t come with the RJ-* connector.
    What is the connection diagram that the EZIO8SA expects? Which pins are used to connect which wires?

    Thanks

    Bert

    Anonymous
    Inactive
    May 22, 2015 at 10:29 am
    Post count: 192
    #44471

    The connections where shown in the older Quick Start Guide. The latest one seems to no longer show it.

    You do know that only one Dallas DS18B20 chip is supported by the EZIO8SA? As shown in the EZIO8SA Quick Start Guide.

    OK from an older EZIO8SA Quick Start Guide. I doubt it has been changed in later production runs.

    RJ12 Connector on the EZIO8SA:
    Pin 1: +5 Volts
    Pins 2,4,6: Ground
    Pin 3: 1 Wire Buss
    Pin 5: No Connection.

    Anonymous
    Inactive
    May 22, 2015 at 11:17 am
    Post count: 192
    #44472

    I found these in my archives.

    Anonymous
    Inactive
    May 27, 2015 at 9:32 pm
    Post count: 146
    #44473

    Hi Bert,

    Sorry for the confusion. We didn’t put that in the latest version of the quick start guide because it’s not commonly used, so we just put those diagrams in the “Resources” section of the product page – http://smartenit.com/product/ezio8sa/

    Thanks BLH for helping out. He should have everything he needs now. Sorry for the delay in response…I stopped getting emails when users post on the forum, for some reason. Need to check that out.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.