using EZIO8SA inputs as event triggers for macros in EZsrve

[Anonymous]

#39991

I have installed and upgraded my EZSrve to v1.52 firmware. I have also tested the EZSrve with several Switchlinc and Lamplinc controls and timers to verify basic operation. I have added an EZIO8SA to the Insteon network and have configured/read/written the inputs from the EZSrve device. Unfortunately, I have yet to understand how to correctly link the EZIO8SA as a server for the individual inputs to send group messages to the EZSrve. I also have not been able to find much documentation on how to configure this messages (separate devices for each input) in EZSrve to use as conditional events in macros. Can someone point me to some more explicit method to enable this. I have two motion detectors (NC) on I1 and I2 and would like to use them to trigger on/off combinations with timers for certain lighting scenes.

Any information would be greatly appreciated.

[Anonymous]

#41923

I still have not been able to link my EZIO to EZServe with the EZServe being a responder. Is there anyway to use SHN to look at and modify the EZServe link table? I have successfully linked the EZIO8SA to other Insteon devices (Switchlinc and LampLinc), but would like to add the EZServe as a responder device and use the group message event from the EZIO8SA input as a conditional event in the EZServe macro. Any advice would be greatly appreciated.

[Author]

Posts