HOME › Forums › Software › SimpleHomeNet Utility › relaying of x10 signals

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • Anonymous
    Inactive
    February 13, 2012 at 7:38 pm
    Post count: 82
    #40330

    Can you please tell me if I am correct in the following?

    The EZX10RF can relay x10 signals. In the Utility if all house codes and numbers are de-selected no X10 signals will be relayed. If all the house codes and numbers are deselected can they still be assigned Insteon Group numbers in order to convert the X10 signal to an Insteon signal?

    thanks,

    bob

    Anonymous
    Inactive
    February 13, 2012 at 9:08 pm
    Post count: 1001
    #43811

    On my v.1C EZX10RF, unchecking an X10 house/unit code stops the Insteon Group message for that X10 house/unit code. It does not stop an RF X10 message from being placed on the powerline.

    Anonymous
    Inactive
    February 13, 2012 at 9:27 pm
    Post count: 82
    #43812

    The EZX10RF overview on the product page states:

    Any of the X10 addresses can be filtered out with a PC based utility

    So why does unchecking the house code and number not prevent the EZX10RF from relaying an X10 signal?

    Anonymous
    Inactive
    February 13, 2012 at 10:49 pm
    Post count: 1001
    #43813

    My apologies. The results I posted were the observed results but I forgot I had another EZX10RF in range of the credit card remote. The X10 messages being traced by my ISY were coming from the other EZX10RF, not the one that had the house/unit code unchecked. When I unplugged the other EZX10RF the X10 messages stopped.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.