I am hoping to use the Smartenit EZX10RF INSTEON / X10 RF INSTEON Device to allow me to convert the X10 signal from an X10 Palm pad or ablenet SiCare Pilot Pro to Insteon so that I can control a number of lights, lamps, door opener, and appliances. The table below shows an example of the X10 command I would like to send and the Insteon device I would like to respond to the command. My initial attempts to set it up have been unsuccessful. I have not been able to get it to create a separate group/seen for each of the X 10 commands. Is it possible to set it up as described? If so I would appreciate it if you to give me a more detailed instructions on how to set it up as in the table below.
X10 code sent
Insteon device
Location
Function
B 2 on/off
2466SW
Hall light
On/off
2466SW
Porch Light
On/off
B 3 on/off
2456S3
Front room lamp
On/off
B 4 on/off/dim/Bright
2466DW
Front room light
On/off/dim/bright
B5 on
2458A1
Front door deadbolt—51890N Lock
B 5 off
2458A1
Front door deadbolt—51890N Unlock
B 6 on/off
2466SW
Bedroom light
On/off
2466SW ToggleLinc Relay – INSTEON Remote Control On/Off Switch (Non-Dimming), White
2456S3 ApplianceLinc – INSTEON Plug-in Appliance On/Off Module, 3-Pin
2466DW ToggleLinc Dimmer – INSTEON Remote Control Dimmer Switch, White
2458A1 MorningLinc – INSTEON Morning Industry RF Doorknob/Deadbolt Controller
51890N MiLocks RF-01SN RF Remote Controlled Keyless Entry Deadbolt, Satin Nickel
