Constant "X10 D9 brighten by 5" signals

[Anonymous]

#40318

Hello – I am getting continual “X10 D9 brighten by 5” at one minute intervals in my Indigo log. I do not have house code D selected so I should not be receiving signals on that housecode. I have no X10 dimmming devices in my house. I remove the EZX10RF and the problem stops. Also I move my Powerlinc to the opposite phase and the problem stops. Someone else using an EZX10RF was also having this problem, see link below;

http://www.perceptiveautomation.com/userforum/viewtopic.php?f=7&t=5536

thanks – bob

[Anonymous]

#43761

Hello Bob,

Sorry I missed this post. Have you resolved this issue yet or perhaps given us a call and already been helped?

Thanks,

Justin

[Anonymous]

#43762

No, no resolution yet. If I unplug the unit the problem goes away. Seems like the EZX10RF is generating these extraneous signals internally for some reason.

[Anonymous]

#43763

Hi Bob,

You can send the device to me so I can test to see if I get the same response…or if you can find a way to isolate the EZX10RF so it can’t receive signal by removing the antenna or putting a tin can around it and see if that stops it, you can better tell if it’s RF interference that is being interpreted as a bright command or something internal that would be generating that signal.

Our engineer says that it’s next to impossible for it to generate the signal by itself…so he suspects that there is some stray RF signal that the EZX10RF is seeing as a bright signal.

[Anonymous]

#43764

Justin,

I’ll try your suggestions and let you know. Thanks for your help.

bob

[Author]

Posts