HOME › Forums › Controllers › EZX10RF › All Units Commands?

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • Anonymous
    Inactive
    August 10, 2007 at 10:45 pm
    Post count: 192
    #39755

    Does the EZX10RF process All Unit Commands? Using my Smarthome 1132CU Advanced Signal Tab received powerline signals display. The All Lights ON and All Units Off commands from a UR19A Remote are not resent on the powerline. Does the EZX10RF process All Unit Commands? I hope so; as I do use them.

    Anonymous
    Inactive
    August 11, 2007 at 12:19 pm
    Post count: 256
    #40974

    The unfortunate answer is NOT at this time. The rationale was to go with the codes implemented by the keyfob, keypads and motion sensors. Are there any other commands we need to add? We could send you a replacement once a new firmware is released.

    Al

    Anonymous
    Inactive
    August 11, 2007 at 1:34 pm
    Post count: 192
    #40975

    Thak you for the information.
    I am not too sure if an All Unit Command would be a highly needed one. Maybe if someone was replacing an exsisting Tranceiver in a mixed system. Like mine since there are no Insteon two wire wall switches and my experience with the now MIA SocketLincs forced me to keep a few X10 switches.

    Anonymous
    Inactive
    August 11, 2007 at 9:14 pm
    Post count: 256
    #40976

    We want this to be the best X10-Insteon receiver ever, so we’ll incorporate the ALL ON and ALL OFF in a future firmware release.

    Anonymous
    Inactive
    September 8, 2007 at 10:48 am
    Post count: 192
    #40977

    Got my new firmware 12 unit yesterday.
    The All Lights on command works fine. The All Units Off command from the Remote is sent back on the powerline as a All Lights Off. That means that any Appliance Type modules will ignore the command and my Switchlinc V2 Relay switches also ignore it. Most of X10s Lamp type modules also ignore that command and only respond to All Units Off; as X10 didn’t support it in a wide range of modules. My LampLinc V2s do respond to an All Lights Off.

    Anonymous
    Inactive
    September 9, 2007 at 11:01 pm
    Post count: 256
    #40978

    Looks like we mimicked th behavior of the X10 IR543.. Let us look into it.

    Anonymous
    Inactive
    September 9, 2007 at 11:55 pm
    Post count: 192
    #40979

    Sounds like a plan to me.

    Anonymous
    Inactive
    January 11, 2008 at 4:57 pm
    Post count: 256
    #40980

    Brian, as you suggested we changed the ALL LIGHTS OFF (0x06) to ALL UNITS OFF (0x00) when receiving the RF All Lights Off command.

    Let us know your impressions with the new EZX10RF features.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.