HOME › Forums › Irrigation › EZFlora › Commands

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Anonymous
    Inactive
    August 30, 2010 at 4:21 am
    Post count: 7
    #40274

    Could someone please point me to the doc or tell me the commands and if I use status or config. when setting up a timed action.

    I am using a new EZFlora and EZServe and I am talking about the web interface for the EZServe.

    The document that I used before is no longer available online. (or at least I cant find it)

    Program 1 = [ ]
    Program 2 = [ ]
    etc…

    Anonymous
    Inactive
    August 30, 2010 at 12:18 pm
    Post count: 1001
    #43485

    I think you are asking about using the HTML interface rather than the Harmony client.

    Status 80-87 to turn On valves 1-8 results in 0x40 cmd1 with 0-7 cmd2 values
    Status 0-7 to turn Off valves 1-8 results in 0x41 cmd1 with 0-7 cmd2 values
    Status 20 turn On Program 1 results in 0x42 cmd1 with 0 cmd2 value
    Status 28 turn On Program 2 results in 0x42 cmd1 with 1 cmd2 value
    Status 30 turn On Program 3 results in 0x42 cmd1 with 2 cmd2 value
    Status 38 turn On Program 4 results in 0x42 cmd1 with 3 cmd2 value

    The EZFlora command set is available in the Downloads section under Command Sets – EZFlora

    EDIT: added Status values for turning on Programs 1-4

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.