Thanks for your work.
I have linked a few devices, but somehow it’s still not seeing when I turn a light or device on unless it commands it on. It’s not responding to X10 or Insteon macros, or showing the correct on-off state.
PDA use with Pocket Internet Explorer 6 still isn’t working right, but it’s usable with workarounds. The lamps at the right of the screen show up as X’s (like when a picture is unavailable on a web page). Clicking on them has no effect, thus you can’t control the device. A workaround that wasn’t in the last version is pressing on or off controls the first (i.e. top) device on the screen. I can set an area with the only device I want to control and use it. My full time server will be turned off today, and I’m setting up areas to use EZserve. That was the goal when i bought it so we’re getting there.
One minor note, the username is still EZServe, but now the password has to have the first letter capitalized (i.e. Simplehomenet). Before it had to be all lowercase. It would be nice in the future releases if you would let us know with the bin file what any changes are to log in. I also can’t change the password, it keeps giving me the message “Old Password Mismatch!”.
Thanks again for your continued work here and I hope these comments help.
Ed

I appreciate your efforts. I’m happy I can turn off my server.
Ed

A quick update:

After doing a reset and re-entering our timers, it looks like the time-based timers are working across multiple days. Timers based on sunrise or sunset don’t seem to work at all – either once or from day to day. This general issue has been around a long time – any idea when it might be fixed?

Also, still curious about what the recommended procedure for memory clear/firmware upgrade process is…

Hi Paul,

Yes, I can confirm there is a Latitude / Longitude value set.

Where in the web interface should I run these commands?

I re-entered the location info again and configured a new timer that uses the sunrise/sunset settings, I’ll let you know what happens.

Thanks!

Hi Paul,

I used the SHN 1.6 utility to use the GetSunriseSunset and all that happens is it seems to repeat the last accepted command.

For example, if you run SHN and immediately go to the EZBridge control tab, enter the above GetSunriseSunset command, the results in the log file show a response to a GetRevision command every time the SendXML button is pressed. You can also enter a bogus command such as help and the reply coming back is Command help Not supported
showing that the command entry box is accepting the input, but if you go back and then enter the GetSunriseSunset command again, you will get the prior Command help Not supported reply back again.

Sorry, but perhaps it’s my fault for not being clear in what I was asking before about the reset procedures…

In the Beta release email, you did mention the ClearFlash command, but what I was wondering is if in addition to the software command to clear memory is there a reccomended procedure for powering up and down and/or using the hardware reset button to clear the EZServer after loading the newest firmware?

Thanks for your help!

-Russ