Status change broadcast message 2013-03-01T00:21:12+00:00

HOME Forums Irrigation EZFlora Status change broadcast message

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • dumais
    Post count: 1
    #40358 |


    I bought an EZFlora last week and I am trying to get Status changed events. This event is supposed to be broadcasted by the EZFlora when a valve goes off or on while running a program.

    I don’t have any valve connected to the device right now, but if I do a Status Request, I get a valid ACK with the expected result (i.e: after 1 minute, I see that Valve1 is closed and valve 2 is open). So could it really be because I have no valve connected?

    Also, how does the linking work? I am using my own software to send command to the EZflora through my PLM. I pressed the SET button 3sec on the ezflora, then on the PLM. Then I pressed SET 3sec on the PLM and then on the EZFlora to establish linking both ways. Is this what is needed? I read somewhere that if the EZFlora is linked, it will not broadcast status changed events. So I unlinked my EZFlora from the PLM (entered unlink mode on EZFlora and pressed set 3sec on PLM, but I did not do the same thing on the PLM). I still don’t get any broadcast messages.

    I should mention that I send command 0x44,0x09 (enable valve status change event) when my software initializes. and I can confirm that bit6 of the control register is set when reading it.

    Post count: 31

    Hi dumais,

    Not sure if this will help you but I was having the same issue where no valve/program status change broadcast messages were appearing even though I had enabled them. For me, the fix was actually to enable “Monitor Mode” on my PLM. By default, it is disabled. Not sure what host controller/software you are using but most should have this property exposed as part of the PLM device you interface through.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.