Hi – I have a simple setup. There is no home automation SW. All the
INSTEON Devices (and the PLM) are manually reset, and manually
ALL-Linked. The EZIO8SA is version 17 according to the SimpleHomeNet
Utility 1.4 (but that’s all I used that Utility for). The cable between the PLM
and the EZIO8SA is sound and works reliably. I would just like to know if
the EZIO8SA is supposed to be “mute” for 6 seconds after receiving a
change on one of it’s inputs. Is my unit defective, or not?
Setup:
switch1 pulls DI1+ up to 12VDC, DI1- to GND
input1 controls Group1
Group1 linked to LampLinc1
switch2 pulls DI2+ up to 12VDC, DI2- to GND
input2 controls Group2
Group2 linked to LampLinc2
First Observed Behavior:
When I close switch1 –> LampLinc1 goes ON
if I keep switch1 closed for at least 6 seconds before opening switch1
when I open switch1 –> LampLinc1 goes OFF
if I open switch1 before 6 seconds
when I open switch1 –> Nothing happens
Second Observed Behavior:
When I close switch1 –> LampLinc1 goes ON
if I don’t touch either switch for at least 6 seconds
when I close switch2 –> LampLinc2 goes ON
if I close switch2 before 6 seconds
when I close switch2 –> Nothing happens