EZIO2x4 input to control output 2008-01-09T00:39:46-08:00

HOME › Forums › Input/Output › EZIOxx › EZIO2x4 input to control output

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • Anonymous
    Inactive
    January 9, 2008 at 12:39 am
    Post count: 2
    #39836 |

    I’m trying to program the EZIO2x4 to close a relay when input2 goes high and open it when input 2 goes low. I can get it to close fine, but it only opens when the timer is set and times out. It times out even if the input condition never cleared. It seems like this can be done, but it has escaped me. Any help is appreciated.

    Anonymous
    Inactive
    January 11, 2008 at 5:20 pm
    Post count: 256
    #41298

    Please use the “Actuate Output” checkbox on the input parameters and disable the timer by writing a 0 for the time. This will work only for inputs 1 and 2 in the EZIO2X4.

    Anonymous
    Inactive
    January 14, 2008 at 12:11 am
    Post count: 2
    #41299

    had to add a 10k resistor between the input and ground. thanks

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.