Controlling the EZIO40 from the SmartLinc 2412N Controller 2013-06-06T11:49:57+00:00

HOME Forums Input/Output EZIOxx Controlling the EZIO40 from the SmartLinc 2412N Controller

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • Anonymous
    Post count: 2
    #40371 |

    I have succesfully programmed the SmartlInc for all my Insteon Lighting Zones and also the EZFlora sprinkler 8 output controller to run my lawn watering system. I used the EZflora download brochure to program the 8 sprinkler valves with the direct on and off codes listed in the brochure. I would like to program the 4 relays of the EZIO4 that I already have so that my Smartlinc can control a swimming pool and spa that I am going to install. The relays would be used to turn on the pool and spa lights at night and also run the circulating pumps on schedule. I cannot find anywhere the command codes such as in the EZflora to do this. I tried using the command codes from the EZFlora brochure with the address of the EZIO40 to do this but the EZIO40 didn’t respond. Where can I find these command codes or this there another way to program this? Help!!

    Anonymous
    Post count: 146

    Hello there Gaylen,

    The command set for all our devices is found in the downloads section of our website – http://simplehomenet.com/support.asp?page_id=supDownloads

    The EZIO devices command set is here – http://simplehomenet.com/Downloads/EZIOxx%20Command%20Set.pdf

    Ex, to turn on relay 1 – 0262??????0F4500 (?????? is the INSTEON ID of the EZIO4O), and to turn off – 0262??????0F4600

    I hope that helps

    Anonymous
    Post count: 2

    Thank you Justin, It works! I will go to your download section from here.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.