Command keeps getting sent 2013-06-30T06:04:40+00:00

HOME Forums Gateways Harmony Gateway Command keeps getting sent

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • Anonymous
    Post count: 7
    #40376 |

    Ok, so from my other thread, I figured out how to write a proper wizard 🙂 Now I have a new problem.

    Not every time – after a wizard fires, it keeps sending the same command over and over for hours.

    For instance I have one right now

    Within 8pm +- 15 minutes, every day, next on 29 Jun 2013 (this seems odd in itself, it should have already fired and have the next as 30 Jun)
    Turn on lights

    well, since this wizard was triggered, I have a command repeating on the line to turn on that light. The light on the side of the Harmony is blinking, and I can see it on my XTBM. It should have just fired once and been done.

    Anonymous
    Post count: 259

    Can you take a picture of this wizard and email it to me please. Thanks.

    Anonymous
    Post count: 259

    This bug has been fixed with Harmony Gateway firmware 1.09 and above.

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.