HOME › Forums › Input/Output › EZIOxx › EZIO2X4 Not Updating Input Status To ISY994 › Reply To: EZIO2X4 Not Updating Input Status To ISY994
AnonymousInactive
April 7, 2014 at 9:09 pm
Post count: 7
Hi Justin,
I’m running into the same problem again with updates only on query, but this time with only with I3 and I4 inputs (I hadn’t attempted to use before).
I have 10,000 ohm resistors across +5V to I3 and +5V to I4 – and when I Ground from I3 or I4 the status only changes when I query ISY. I want to use I3 and I4 as “dry contact” inputs. Any special programming needed from the Smartenit Utility Suite? I did a factory reset with the utility, as well as with the reset button.
What could I be missing?
Joe