Reply To: Status change broadcast message 2017-12-21T11:56:37+00:00

HOME › Forums › Irrigation › EZFlora › Status change broadcast message › Reply To: Status change broadcast message

Anonymous
April 17, 2013 at 3:20 pm
Post count: 31
#43948

Hi dumais,

Not sure if this will help you but I was having the same issue where no valve/program status change broadcast messages were appearing even though I had enabled them. For me, the fix was actually to enable “Monitor Mode” on my PLM. By default, it is disabled. Not sure what host controller/software you are using but most should have this property exposed as part of the PLM device you interface through.