HOME Forums Controllers EZX10RF Can’t link after update Reply To: Can’t link after update

Post count: 82

Then I have it set wrong as the links I sent you have the 2413U set as the controller when it is actually the responder. The links I sent should have the address of the EZX10RF set as the controller.

I am using a separate 2412S PLM just for the Utility and I have a 2413U for use with Indigo so I can write links to the 2413U?

So I have to set links in the 2413U to set it as a responder to the address of the EZX10RF?