Reply To: EZX10RF putting out wrong addresses 2017-12-21T14:50:57+00:00

HOME Forums Controllers EZX10RF EZX10RF putting out wrong addresses Reply To: EZX10RF putting out wrong addresses

Anonymous
Post count: 1001

It sounds like full X10 message sequence is not being sent. X10 messages are sent in two segments. The first is House/Unit, the second is house/command. The following is a sample from an ISY where an X10 D9 On command is sent on the powerline, with the X10 message segments followed by the EZX10RF node for D9 reporting an On state. Although the ISY annotation says D9/On the message segment is actually only D/On. The unit number 9 is assumed from the previous X10 segment. If the first X10 message segment is not sent or not received the wrong node will respond.

Sat 01/29/2011 05:08:56 PM : [X10-RX ] 02 52 A7 00

Sat 01/29/2011 05:08:56 PM : [ X10] D9

Sat 01/29/2011 05:08:57 PM : [X10-RX ] 02 52 A2 80

Sat 01/29/2011 05:08:57 PM : [ X10] D9/On (3)

Sat 01/29/2011 05:08:57 PM : [INST-SRX ] 02 50 01.DB.DE 00.00.05 CB 11 00 LTONRR (00)

Sat 01/29/2011 05:08:57 PM : [Standard-Group][01.DB.DE–>Group=5] Max Hops=3, Hops Left=2

Sat 01/29/2011 05:08:57 PM : [ 1 DB DE 5] DON 0

Sat 01/29/2011 05:08:57 PM : [ 1 DB DE 5] ST 255

Sat 01/29/2011 05:08:58 PM : [INST-SRX ] 02 50 01.DB.DE 12.9F.E4 41 11 05 LTONRR (05)

Sat 01/29/2011 05:08:58 PM : [Standard-Cleanup][01.DB.DE–>ISY/PLM Group=5] Max Hops=1, Hops Left=0

What does your event viewer trace show? Can you post a sample.