Reply To: Getting it working after a factory reset 2017-12-22T09:52:57+00:00

HOME Forums Gateways EZSrve Getting it working after a factory reset Reply To: Getting it working after a factory reset

Anonymous
Post count: 1001

Try clicking on the SET TIMEZONE button after setting the information. Then unplug the EZSrve for 30 seconds. After a few minutes to allow for the EZSrve to reboot verify the time, date and zone are correct.

What image did you migrate from and to?

Which Actions are not triggering, Event based, Time based, None ?

Are the Actions viewable?

As a side note for anyone who loses a password, there is an XML command that can be issued through the SHN Utility that will reset the password. Select EZSrve/EZBridge | Control , enter XML command from API document in Data to Send pane and click on Send XML.