Okay. Post back if you want to pick it up later. My ICON switches are very old. They were purchased near the beginning of Insteon. I’ve tried both ICON On/Off and Dimmer variants and both work the same. The ICON Quick Start Guide calls for the ICON status LED to blink when it enters controller linking mode. You cannot deviate from the prescribed Set button press sequence for the EZIO2X4 to compensate for the unusual behavior of the ICON switch. The EZIO2X4 link will not turn out correctly with a different Set button sequence.
Reply To: Can’t manually link Ezio2x4 output grif091 2017-12-22T00:57:21+00:00