Reply To: Linking RemoteLinc button to EZServe 2017-12-22T06:57:09+00:00

HOME Forums Gateways EZSrve Linking RemoteLinc button to EZServe Reply To: Linking RemoteLinc button to EZServe

Anonymous
Post count: 3

Thanks for your reply!

I held button 3 on the RemoteLinc until it beeped and the LED started blinking. I held the Set button on the EZSrve until the LED on the RemoteLine went out. So far, so good.

But if I go to the macro page, the dropdown list for the “If Device” does NOT list the RemoteLinc and does not allow me to enter anything myself. And where do I enter the hex code? All I have is a dropdown list for “Does” that also does not allow me to enter anything myself. I see in the manual that there should be an input field next to the “Does” dropdown list, but my page does not have this input field. Also, the manual says that the “If Device” can be edited, but my pages does not allow it – I can only choose what’s in the dropdown list.

I am using version 1.6 of the firmware (this is what the EZSrve came with).