Reply To: Ramp Rates and Preset Dim other than X*20% 2017-12-22T06:52:38+00:00

HOME Forums Gateways EZSrve Ramp Rates and Preset Dim other than X*20% Reply To: Ramp Rates and Preset Dim other than X*20%

Anonymous
Post count: 1001

I traced the command activity on mine when I added EZServe as the Controller to a new scene. The only command issued is a Status Request 0x19 command which echo’s back with 0x00 status. Use the SHN Utility to trace the command sequence when you add EZServe to a new Scene. Perhaps it is responding with some status that does not permit the Scene creation process to continue. The following are the SndIns and InStdMsg messages from the log.txt file when I added EZServe as the Controller.

A few housekeeping questions, is this a new EZSrve or EZBridge? What image level are you running on? Was it purchased from SimpleHomeNet or SmartHome? It is the first time I have seen an Insteon device address start with 0x01. Is this the first Scene you are trying to create with EZServe as a Controller?



Message : 9:04:15 PM Thursday, January 15, 2009
:
:
GetRevisionRevision 01.59



Message : 9:09:34 PM Thursday, January 15, 2009
:
:
SndIns
0X2
0X62
0X6
0X4C
0XA5
0XF
0X19
0X00
0X6



Message : 9:09:34 PM Thursday, January 15, 2009
:
:
InsStdMsg
0X2
0X50
0X6
0X4C
0XA5
0X6
0X4C
0XA5
0X3
0X19
0X00