Reply To: EZServer 1.58 error message "link could not be created& 2017-12-21T22:22:06+00:00

HOME Forums Input/Output EZIOxx EZServer 1.58 error message "link could not be created& Reply To: EZServer 1.58 error message "link could not be created&

Anonymous
Post count: 1001

I just did the following activities on Image 1.58 to be sure Image 1.58 did nothing to prohibit creating links between the EZIO2X4 and EZSrve. Also tested the Macro Group number recognition introduced at Image 1.58.

Used the SHN Utility connected to EZSrve to set Input 3 (AN1) to Group 3 and Input 4 (AN2) to Group 4.

Used EZSrve Scenes Management to create a link from the EZIO2X4 Input 3 (as controller, Unit 03) to EZSrve as the responder. Used EZSrve Scenes Management to create a link from the EZIO2X4 Input 4 (as controller, Unit 04) to EZSrve as the responder.

Created 4 EZSrve macros:

M2X4I3On If Device: DEZIO2X4 Does: 1103 Then Device: LampLinc Does: ON

M2X4I3Off If Device: DEZIO2X4 Does: 1303 Then Device: LampLinc Does: OFF

M2X4I4On If Device: DEZIO2X4 Does: 1104 Then Device: LampLinc Does: 1180

M2X4I4Off If Device: DEZIO2X4 Does: 1304 Then Device: LampLinc Does: OFF After Delaying: 00 00 10

Input 3 (AN1) ON turns On the LampLinc at full intensity.
Input 3 (AN1) OFF turns Off the LampLinc
Input 4 (AN2) ON turns On the LampLinc at half intensity.
Input 4 (AN2) OFF turns Off the LampLinc after 10 second delay