With the MSB change you now can create a controller link in the EZSnsRF for each of the Virtual Inputs that are active. The EZSnsRF uses Group commands to signal the On or Off of each Virtual Input. A Controller Of link in the EZSnsRF is required for each active Virtual Input so the Group protocol will know where to send the On and Off commands. In this case I assume it would be the EZSrve as the responder so macros could be defined to accomplish other activities. More than one controller of link can be established in the EZSnsRF for each Virtual Input so that direct control of one or more Insteon devices are possible along with notifying the EZSrve that the On/Off has occurred. I single link established at device add time does not work for the EZSnsRF where each Virtual Input requires a link.
Reply To: fw 1.57 setting macro for EZSnsRF grif091 2017-12-21T19:46:40+00:00