Reply To: trying to get EZIO2X4 to Control Somfy Drapery controller 2017-12-21T22:52:55+00:00

HOME Forums Input/Output EZIOxx trying to get EZIO2X4 to Control Somfy Drapery controller Reply To: trying to get EZIO2X4 to Control Somfy Drapery controller

Anonymous
Post count: 1001

After Reading the Output timer values, go to Insteon Traffic tab and Clear both left and right windows. The EZIOxx Insteon ID will not be lost during the tab change. Go back to the EZIOxx tab, change the Timer value, click Write. Then go back to the Insteon Traffic tab and note the commands in both left and right window and post those back. I should be able to tell what is happening from that. Also, after entering the Insteon ID on the EZIOxx tab, below that input field is displayed Connected ???. The ??? value is the firmware level of the EZIO2X4. Post that back as well. Thanks

EDIT: this is what the command sequence is expected to look like. Both Output Timers were set to 7 originally. I set Timer 1 to 4 and Timer 2 to 3 and then clicked on Write.

To ID:0c.ae.5f flags:0F cmd1:28 cmd2:0 from ID:0C.AE.5F flags:23 cmd1:28 cmd2:0
To ID:0c.ae.5f flags:0F cmd1:2B cmd2:0 from ID:0C.AE.5F flags:2B cmd1:2B cmd2:7
To ID:0c.ae.5f flags:0F cmd1:29 cmd2:4 from ID:0C.AE.5F flags:2B cmd1:29 cmd2:4
To ID:0c.ae.5f flags:0F cmd1:2B cmd2:1 from ID:0C.AE.5F flags:2B cmd1:2B cmd2:7
To ID:0c.ae.5f flags:0F cmd1:29 cmd2:3 from ID:0C.AE.5F flags:2B cmd1:29 cmd2:3
To ID:0c.ae.5f flags:0F cmd1:4F cmd2:1 from ID:0C.AE.5F flags:2B cmd1:4F cmd2:1

Don’t worry if they don’t make sense. Just post back your results and I
will interpret.

EDIT2: I also posted this under the Simplehomenet Utility.

In looking at the SHN Utility source to see how hard it would be to save the last Insteon ID of the EZIOxx device I discovered the mechanism is already there. Double click on empty Insteon ID field and the Device Type and Insteon ID fields are primed with the last used values.