Reply To: X10 Problem with Macros 2017-12-21T22:15:31+00:00

HOME Forums Gateways EZSrve X10 Problem with Macros Reply To: X10 Problem with Macros

Anonymous
Post count: 1001

Unless you missed posting the second of the A01 ON X10 message segments, the only thing in your post is the first A1 (house/unit) message segment in the one SndX10 command. There should be two SndX10 commands. The first (in time) being the house/unit code (A1) and the second (in time) being the house/command code (A ON). You do show both X10 messages being received for the M01 ON. The first (bottom up) being the M1 and the second (bottom up) being the M ON.

The following are the two SndX10 messages generated by a Timer turning A01 ON. These are from my log.txt file so the top one is the first in time being the 0x66 A1 (house/unit), the second is the 0x62 A ON (house/command), which is missing in your post. Unless you saw that second SndX10 message on your system and it got lost in the posting process, you are also missing the second part of the A01 ON X10 message sequence when issued by a Macro.

Set up a Timer to do an A01 ON while the SHN Utility is running. You should see two SndX10 messages when A01 ON is issued by a Timer (as below). Compared to a Macro doing an A01 ON where only the first of the two required SndX10 messages is generated.


Log file entries from a Timer A01 ON


Message : 5:15:58 PM Sunday, July 13, 2008
:
:
SndX10
0X2
0X63
0X66 A1
0X00
0X6



Message : 5:15:59 PM Sunday, July 13, 2008
:
:
SndX10
0X2
0X63
0X62 A ON
0X80
0X6