Reply To: sending x10 XML to EZSrve 2017-12-22T06:42:01+00:00

HOME Forums Gateways EZSrve sending x10 XML to EZSrve Reply To: sending x10 XML to EZSrve

Anonymous
Post count: 408

First, here are the available commands

“All-Lights-OFF”, “Status=OFF”, “ON”, “Pre-Set:Bright”, “All-Lights-ON”,”Hail-Acknowledge”, “Bright”, “Status=ON”,”Extended-Code”,”Status-Request”, “OFF”, “Pre-Set:Dim”,”All-Units-OFF”,”Hail-Request”,”Dim”, “Extended-Data(analog)”

Note that they are case sensitive. Use the higher level command. When you use the low level, you can send the raw hex, but you need to send first the house unit, then the house / command code. Timing is important as well – we take care of that with the high level command.

You can also use the raw hex with the command for the high level.

So, try the following:

SendX10
A
6
ON

With the high level command, don’t use the leading zero.