Reply To: Firmware 1.30 Release 2017-12-21T17:10:10+00:00

HOME Forums Gateways EZSrve Firmware 1.30 Release Reply To: Firmware 1.30 Release

Post count: 18

Before I upgraded to 1.3 from 1.2, I did a reset to factory defaults via the web interface.

After loading the 1.3 firmware, the areas that I was using under 1.2 are still visible. However, the devices that went in those areas are not.

I like that the sunrise/sunset times are now displayed – I’ve never been able to get them to work, but now I see they are correct.

As with the areas being maintained from 1.2 to 1.3 (even after a reset via the web page, as noted above) the lat/lon is maintained as well.

When adding devices, it appears you can’t just give it the device address – you still need to press the link button on the device. Unlike previous versions though, it doesen’t seem to pop up that dialog that instructs you to press the button.