Thanks for your post and sorry for my wrong device information. The KPL information from the labels is V1.4 2335, 2486D 0643, and from Houselinc Desktop “Properties”, Firm 41 (2.9). After a factory reset on the 2X4 I tried linking Input 1 on the 2X4 to a Lamplinc using the Set button technique so no software was involved in the linking process and got the same results. The Lamplinc did establish a link for the 2X4 and the 2X4 does have a link for the Lamplinc but the 2X4 went into the same Group Broadcast/Group Cleanup Direct message sequence for Group FF that can only be stopped by powering the 2X4 off. The Lamplinc information from the labels is V2.6 4613, 0644 Rev 2.7, and from Houselinc Desktop “Properties”. Firm 40 (2.8). I ordered a new EZIO2X4 last week. Plan is to check the level of the new one and query the device information before trying any configuration changes or linking. Could not think of anything else to try. Any new ideas would be appreciated.
Reply To: EZIO2X4 Sending OFF Commands To Group FF Forever grif091 2017-12-21T14:46:20+00:00