HOME Forums Gateways EZSrve EZSrve Firmware 1.20 Release Reply To: EZSrve Firmware 1.20 Release

Post count: 57


I have mostly ApplianceLincs with 2 Icon Appliance Adapters. With rev 1.00, they both got configured as OTHERS for the device type. It looks like you’ve fixed that and that the address gets looked up – but – the Icon device (which I tried to config as an ApplianceLinc but which gets reset to Icon) doesn’t let me _do_ anything in the timers section!

If I select the Icon device, then the Command drop-down just gives me one choice: “No Command to select”…..

I’m going to try to config as OTHERS to see if that will stop the lookup, but I notice that the “electronic linking” doesn’t seem to have an equivalent “electronic un-linking” so I get to run all over pushing buttons!