Just had the chance to upgrade to the latest 0.32 firmware.
Is there a recommended procedure for loading the firmware? (e.g.: hardware reset, load firmware, power off/on)
As with past upgrades, I’ve just been loading it in without any resets or restarts before or after.
What surprised me after loading 0.32 over 0.31 was that all the old data was still there (addresses, areas, timers).
So far I haven’t seen the timers work any better than the 0.31 build – they work fine once, but not the next time. The sunrise and sunset timers still don’t seem to work at all.