Reply To: Configuration in Simplehomenet Utility Suite 2017-12-22T09:55:24+00:00

HOME Forums Controllers EZX10RF Configuration in Simplehomenet Utility Suite Reply To: Configuration in Simplehomenet Utility Suite

Anonymous
Post count: 256

You can link the PLC device as a responder (slave) like you would any other Insteon device. Simply put the EZX10RF in linking mode (learn a code, then set timer, then push button to start linking). Once the EZX10RF is linking (LED flashing rapidly), press and hold the button on the PLC for about 10 seconds. A successful link will be indicated by the LED going steady again on both units.
DO BEAR IN MIND: It is then up to the given application (HomeSeer, mControl, or other) to do something when the PLC gets the group message. You’ll have to consult with the software manufacturer to see what it does.
Also keep in mind that multiple devices can be linked on the same house/unit code (or group). Just start a new link with the desired code that was used previously.