Did anyone find resolution on this? Thank you to Simplehome – I have a unit that is working correctly in the hardware sense. However, I’m now having problems getting it programmed.
I can store times into the unit (with the occasional error stating “Error Sending Message – Please Confirm EZRain Module ID or Retry Command”). However, when I “Get” the times back, it has randomly changed them. In the Manual section it typically brings back the same stored times of 80, 4, 0, 32, 128, 0, 0, 0. The 80 in Zone 1 typically changes to various numbers. However, the 4, 32 and 128 always come up. The other programs 1-4 typically just dont’ store the times I put in there. And if they do store once, they are gone very quickly and replaced with zeros or other random times (the most recent being 30 minutes).
Seems like it should be simpler than this – I’ve been spending a ton of time trying to get this configured!