HOME › Forums › Input/Output › EZIOxx › Using EZIO8T for 1Wire + Open/Close Sensor › Reply To: Using EZIO8T for 1Wire + Open/Close Sensor
Inactive
October 16, 2007 at 3:15 am
Post count: 4
I am using Indigo 2
I tried first to unplug then replace the sensor
this did not work
the only operation that did was to pull the power from
the EZIOSA and 8T then re-sync them with the Indigo
software and set them up for one wire temp status.
the readings I would receive were 0 or 255
The rest of the communications for the units seemed to be working
thru out this failure.